Settings In Automatic Mode; Starting A Charge / Discharge Process - ROBBE POWER PEAK ULTIMATE 2 Manual De Uso

'MODE'
button
6.2

SETTINGS IN AUTOMATIC MODE

In automatic mode the charger sets the optimum current and voltage values automatic-
ally; this mode is available only for NC and NiMH batteries. The 'MODE' button is used to
select the three available processes (CHARGE, DISCHARGE, DISCHARGE ‡ CHARGE)
for the two battery types.
If a battery is connected, pressing the 'START' button initiates the selected process. An
audible beep now sounds, and the screen display changes to show the charge parame-
ters. The top line shows the process - Charge (C) or Discharge (D) - and the charged-in
or discharged capacity. The top line also displays the time elapsed since the start of the
process. The bottom line shows the battery type, the current battery voltage and the char-
ge current. To indicate that the charger is in automatic mode, the current display alterna-
tes with the word 'auto'.
Pressing the 'STOP' button at any time interrupts the process, and the screen reverts to
the Automatic Mode display. At the end of the process, when the battery is fully charged
or discharged, the screen shows the final values (charged-in or discharged capacity, pro-
cess duration, battery type, battery voltage and current).
6.3

STARTING A CHARGE / DISCHARGE PROCESS

'START' line, and press the 'ENTER' button to confirm your selection.
not fit in one line, the bottom line alternates. Pressing the 'START' button initiates the pro-
cess, and the charger emits a beep. Pressing the 'STOP' button at any time halts the pro-
cess.
Operating instructions
POWER PEAK ULTIMATE 2
'START'
button
When you connect the device to a power source,
the charger automatically activates the memory you
last used. Use the '+' or '-' button to navigate to the
The display now changes, and the top line shows
the set process while the bottom line shows the
selected parameter. Since all the parameters will
10
No.
8470