Lcd Display - miniland baby digimonitor 7" Manual De Instrucciones

LCD DISPLAY

Icons:
Signal strength indicating connection between units:
Channel number indicator:
Lullaby selection
TROUBLESHOOTING
Problem
Screen turns
on and off
No reception
at Monitor
No transmission
at Camera
Blurred image
Functional Switches explanation:
Volume (High Mid Low), (13)
It is used to adjust the sound volume on Baby unit at your preferred level.
Camera Auto (12)
When it is switched to Camera position, the camera will transmit continuously with non-stop.
Whereas it is switched to Auto position, the camera will only transmit when it is activated by
sound.
Transmission HI/LOW (8)
When it is switched to HI position, it can reach 300m in open field with its original transmitting
power. Whereas it is switched to LOW position, the transmitting distance is about 150m in
open field.
ch1
Possible Cause – things to do/check
-The AUTO mode is selected on the camera, when there is no noise
detected by the camera it stops transmitting to save power.
Screen then turns off.
Select the CAMERA MODE on the camera to disable this function.
- Unit has not been switched on.
- AC/DC adaptor has not been connected.
- Adjust the position of the Camera or Monitor
- The transmitter may not be transmitting. (either not powered on or in
voice activation mode)
- Wrong Channel
- Unit has not been switched on.
- AC/DC adaptor has not been connected.
- Check if the CAMERA AUTO mode is switched on.
- The camera lens is not properly adjusted.
- Move the camera lens (3) to focus the image.