Emptying The Grass-Catcher - Sabo 72-12 HF Manual Del Operador

24
EN
Hydrostatic transmission
Move on slopes with the speed change lever in the «N» position, (to take advantage
of the hydrostatic unit's braking effect) and then further reduce the speed using the
brake, if necessary.
DANGER!
Control of the machine could be lost, particularly on slippery surfaces.

5.3.5 Emptying the grass-catcher

NOTE
the blade disengaged, otherwise the engine stops.
When the grass-catcher is full an audible warning is given.
STOP FORWARD MOVEMENT, in order not to block the
collector channel, and disengage the blade which will
stop the audible signal.
Empty the grass-catcher by lifting it using the handle.
NOTE
heard on engaging the blade even when the grass-
catcher has been emptied. This is due to grass cuttings left on the sensor of the mi-
cro-switch. To stop the signal, either remove the remaining grass or disengage the
blade and then immediately engage it again.
5.3.6 Emptying the collector channel
Cutting very tall or wet grass, particularly at too high a speed, can cause the collector
channel to become blocked. Should this happen, it will be necessary to:
– stop forward movement, disengage the blade and stop the engine;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings going in through the exit of the collector channel.
WARNING!
5.3.7 Summary of the main conditions whereby the safety devices
permit or stop work
The safety devices work in two ways:
– by preventing the engine from starting if all the safety requirements have not been
met;
– stopping the engine if even just one of the safety requirements is lacking.
Never use reverse for reducing speed going downhill.
This operation can only be done with
At times the audible warning may be
This must only be done when the engine is stopped.
HOW TO USE THE MACHINE