How To Install The Wheel - Hitachi Koki CM14E Manual Del Operador

How to Install the Wheel

Bar Tool
Hole the Large Pulley
GB
Box Wrench 17×19 mm
Remove Wheel Bolt,
Washers and Outer
Flange
Cutting Wheel
Insert the bar tool.
Rotate the drive shaft until the hole in the large pulley and the bar tool
aligned.
Unscrew wheel mounting bolt with the 17 mm end of the box wrench or your
fi ngers.
Remove wheel bolt, washers and outer fl ange, leaving inner fl ange in place.
Mount wheel on arbor between the two fl anges.
Install fl at washer, lock washer and wheel bolt.
Tighten bolt securely.
Before tightening, check that fl anges are properly seated and not
cocked on the mount or bolt threads. Do not make bolt so tight
as to destroy the cushion supplied by the wheel blotters. Never
fasten while applying your weight. Otherwise the thread could be
broken. Do not tighten more than 20 N•m (200 kgf•cm).
Inner and outer fl anges are not interchangeable. Reversing
positions may cause wheel damage and lock the wheel.
NOTE
Arm may be removed and remounted with wheel on the outboard side of
the arm as required for certain procedures. See page 19 for details.
Inner Flange
Arm
Tighten
22 mm Adapter
WARNING
Outer Flange
Flat Washer
Lock Washer
Wheel with Blotters
14
Wheel Bolt