Disposal Of The Packaging; Requirements On The Installation Site; Electrical Connection - UNITED OFFICE ULG 350 B1 Instrucciones De Uso

Disposal of the packaging

The packaging materials have been selected for their environmental friendliness
and ease of disposal and are therefore recyclable .
Dispose of packaging materials that are no longer needed in accordance with
applicable local regulations .
Dispose of the packaging in an environmentally friendly manner .
Note the labelling on the packaging and separate the packaging material
components for disposal if necessary . The packaging material is labelled with
abbreviations (a) and numbers (b) with the following meanings:
1–7: Plastics,
20–22: Paper and cardboard,
80–98: Composites

Requirements on the installation site

For safe and flawless operation of the appliance, the installation site must comply
with the following requirements:
■ When setting it up, place the appliance on a firm, flat and horizontal surface .
■ Set up the appliance so that there is at least 30 cm of free space in front of
the laminator . Otherwise, the pouch will not be ejected completely from the
laminator after lamination .
■ Do not operate the appliance in a hot, wet or very humid environment or
close to combustible material .
■ The mains power socket must be easily accessible, so that the power cable
can be easily disconnected in the event of an emergency .

Electrical connection

IMPORTANT
► Before you connect the appliance, compare the connection data (voltage
and frequency) on the data plate with that of your mains power network .
This data must match in order to avoid any damage to the appliance .
► Ensure that the power cable is undamaged and is not routed over hot
surfaces and/or sharp edges .
► Ensure that the power cable is not taut or kinked .
► Do not let the power cable hang over edges (trip wire effect) .
♦ Insert the plug into a mains power socket .
■ 48 │ GB │ MT
ULG 350 B1