PHARO EL40 Instrucciones De Montaje página 35

Closing the Programmenu
Resetting to the factory
Programsettings
+
1
2
3
Resetting to the factory
settings for mixer tem-
perature / setting curves
+
1
2
3
Press the >42° button to leave
the Program menu.
Press the >42° + Overhead
shower (1) buttons at the
same time for at least 5 sec-
onds until RES (2) is displayed.
(Press the >42° button again if
you wish to interrupt this proc-
ess.) Now press the MODE
(3) button: The reset is per-
formed.
Press the >42° + Hydromas-
sage (1) buttons at the same
time for at least 5 seconds until
trC (2) is displayed.
(Press the >42° button again if
you wish to interrupt this proc-
ess.) Now press the MODE
(3) button: The reset is per-
formed.
Setting/Adjusting
You can leave the menu at any
time without storing the new
data.
This program item resets all
program values to the factory
settings.
Running this program item
resets all system configuration
values to the factory settings.
35