Installing The Foot Support - Ottobock Lisa Instrucciones De Uso

2) Open the transport safety device (see fig. 2).
3) Lift the rehab buggy by the push handles. Place one foot behind a rear wheel and tip the rehab buggy up and
over the rear wheel (see fig. 3).
4) Move the folding lever under the seat surface (ball grip) down in a semi-circular motion and unfold the rehab
buggy (see fig. 4).
NOTICE! Make sure that the slides are resting completely on the stops.
5) Push the folding lever on the back support (ball grip) downwards to the stop (see fig. 5).
1
3
5

5.2 Installing the foot support

Initial installation
The foot support is not assembled with the two foot support bars upon delivery:
1) Pull the pivot bearings up and turn them to the front (see fig. 6, item 1). Allow the pivot bearings to engage
downward into place.
2) Loosen the clamping screws (see fig. 6, item 2).
3) From below, slide the foot support bars to the same height in the clamping parts of the pivot bearings (see
fig. 6, item 3) and tighten the clamping screws slightly.
Lisa
2
4
Preparation for use
47