Required Accessories; Using The Product In The Vehicle - Ottobock Lisa Instrucciones De Uso

Use
INFORMATION
For transporting children up to 36 kg, Ottobock urgently recommends using a restraint system for children
(known as a child car seat) tested according to ECE 44.03 or higher, or a restraint system according to ECE
44.04 developed especially for children with disabilities. Observe the legal regulations for your country/state in all
cases.
The product may be used as a seat in vehicles for transporting persons with reduced mobility.
During transport in vehicles for transporting persons with reduced mobility, the product must be sufficiently
secured with attachment straps.
The transport weight of the person to be transported in a vehicle for transporting persons with reduced mobility
corresponds to the maximum permissible user weight (see Page 72).

6.6.1 Required accessories

The eyebolts on the front and rear frames are already mounted ex works.

6.6.2 Using the product in the vehicle

The product has been tested according to ANSI/RESNA and ISO 7176-19.
Securing the product in the vehicle for transporting persons with reduced mobility
1) Position the product in the vehicle for transporting persons with reduced mobility. For more information, please
refer to section 5 in the brochure "Transporting persons with reduced mobility", order number 646D158.
2) Engage the attachment straps at the front and rear before tightening them.
→ The product showing the correct positioning of the attachment straps (see fig. 68).
68
Placement of the restraint system integrated in the vehicle
1) Place the passenger in an upright seated position.
2) Pull each end of the restraint lap belt from the inner side of the seat between the upholstery and frame through
to the outside (see fig. 69).
3) Hook the end of the restraint lap belt onto the pin (see fig. 70).
→ The restraint lap belt is pulled through and fastened.
69
68
70
Lisa