Replacing A Scratch Proof Visor; Replacing A Valve Disc; Replacing The Anti-Fog Visor; Storage - Dräger CPS 7900 Instrucciones De Uso

Storage

5. Insert glove with support ring or new glove combination
through the arm ring and align:
The left glove goes into the left sleeve, and the right into

the right sleeve.
The back of the hand points to the sleeve seam.

6. Push the glove unit into the arm ring until the edge of the
support ring is in contact with the edge of the arm ring.
The support ring must sit completely in the gap of the arm
ring.
7. Fit overglove (if desired):
Pull the cuff of the overglove over the arm ring and fasten
with the corresponding rubber ring.
8. Check the seal on the chemical protective suit (see
Chapter 6.5 on Page 28).
6.7.2

Replacing a scratch proof visor

1. Remove the old scratch proof visor.
2. If necessary, remove left-over adhesive.
CAUTION
!
Do not use any pointed or sharp objects or any
solvents so as not to damage the visor!
Generally, the adhesive can be wiped off with your
thumb.
3. Remove the protection film from one side of the adhesive
pads and position the adhesive pads on the old adhesive
points.
4. Remove the protection film from the second side of the
adhesive pads.
5. Center the new scratch proof visor and press it firmly onto
the adhesive pads.
6.7.3

Replacing a valve disc

1. Unfasten protective cap and old valve disc. Do not damage
the valve housing plug.
2. Fit a new valve disc.
3. Place the protective cap onto the training suit.
6.7.4

Replacing the anti-fog visor

CAUTION
!
Danger of material damage!
Do not use any pointed or sharp objects or any
solvents so as not to damage the anti-fog visor.
1. Carefully remove the anti-fog visor from the rubber profile
of the head cover.
2. Insert a new anti-fog visor:
a. Remove the protective foil from the anti-fog visor.
b. Turn the hood of the chemical protective suit inside out.
Ensure that the zip is not overstretched and the sealing
surface does not tear.
c. Align the anti-fog visor using the centre marking and
slowly insert the rubber profile.
30
7 Storage
7.1

Storage conditions

CAUTION
!
If you fail to ensure proper storage conditions, the
chemical protective suit may be damaged!
Store the chemical protective suit in a dark, cool, dry and

airy place without pressure or stress.
Keep out of UV light and direct sunlight; avoid ozone.

Observe the storage temperature (see Chap. 9 on

Page 32).
7.2

Preparing for storage

1. Close the fastener system up to approx. 5 cm before the
end. Regularly check whether the fastener system is still
adequately greased.
2. Pull the flat bag supplied over the hood in such a way that
the cylindrical visor remains in shape.
3. If the chemical protective suit is folded together, pull the
supplied flat bag over the safety boots so that the chemical
protective suit is not discoloured.
7.3

Storage of the chemical protective suit

The following storage options are possible:
Lay the chemical protective suit flat during storage. If the

chemical protective suit is stored in the utility vehicle, avoid
wear due to constant friction against the storage surface.
Hang up the chemical protective suit on an appropriate

hanger or a hanging rail. The hood or protective boots must
be in contact with the ground.
Fold up the chemical protective suit and store it in a

transport case, storage bay or carrying bag.
Pack the chemical protective suit in a CPS storage and

transportation bag.
NOTICE
i i
Dräger recommends packing the chemical protective
suit in the CPS storage and transportation bag to
protect it from environmental influences and to extend
maintenance intervals.
Dräger CPS 7900