Setting Idle Power; Completing 1St Commissioning; Settings For Data Connections (Optional); Settings For The Ethernet Connection - Vaillant VPV I Serie Instrucciones De Funcionamiento

7 Start-up
◁
The Entry ok? confirmation prompt appears in the
display.
7. Answer the confirmation prompt with "Yes" by pressing
and holding for at least one second.
8. Press .
Condition: The country setting is incorrect.
▶
To reset the country setting, read the information on the
installer level (→ Page 37) in the appendix.
▶
Then carry out initial start-up (→ Page 31) again.

7.1.1.7 Setting idle power

1. Open Reactive power.
Note
Further information about idle power can be
found in appendix A.
2. Select Mode and press
3. Select the required type of idle power characteristic and
press .
4. Press .
Condition: You have not selected cosPhi = 1 as the type of idle power char-
acteristic for Mode.
▶
Select the required template in Load Defaults and press
.
▶
Press .
▶
Press and set the Number of nodes.
▶
Press .
▶
Press .
▶
Select the first Node that you want to set and press
.
▶
Set the required parameter value for the Node and
press .
▶
Set the parameters for all of the grid points as described
above.
▶
Press .
1 2
Xxxxxxxxxxxx
5
1 Y-axis
2 X-axis
3 Overexcitation arrow
symbol
5. Select Display curve and press
32
.
3
4
4 Underexcitation arrow
symbol
5 Grid points (in the ex-
ample: Four grid points)
.
6. The previously set characteristic for the Reactive
power is now displayed graphically, as shown in the
example.
7. Press .

7.1.1.8 Completing 1st commissioning

1. Open Finish.
Condition: The menu items for the installation assistant have not been com-
pletely set.
▶
The message Settings are incomplete appears.
▶
Then press to correct the settings.
▶
Complete the 1st commissioning again.
Condition: The menu items for the installation assistant have been com-
pletely set.
▶
Open Finish.
▶
The confirmation prompt Are all settings correct? ap-
pears.
Condition: The menu items for the installation assistant have not been set
correctly.
▶
To correct incorrect settings, press
▶
Correct the incorrect setting in the installation assistant.
▶
Then complete the 1st commissioning again.
Condition: The menu items for the installation assistant have been set cor-
rectly.
▶
Press and hold for at least one second.
◁
The inverter restarts and synchronises with the net-
work.
▶
Switch the load isolator to position (1) in order to switch
the inverter to direct current.
▶
The 1st commissioning is complete and the inverter is
operating.
7.2

Settings for data connections (optional)

▶
Observe the manufacturer details for externally connec-
ted products.
7.2.1

Settings for the Ethernet connection

1. Ensure that the inverter is connected to an Internet
router or another approved product at the Ethernet port
(→ Page 29).
Note
Only change settings on your inverter if the
required connection cannot be automatically
established.
Condition: The network connection with Internet router is not automatically
established (no DHCP).
▶
Open Main menu → Settings → Network.
▶
Observe the information about the menu items in
the Overview of the end user and display functions
(→ Page 9) in the operating instructions.
▶
Set up the inverter for the data connection to the con-
nected product (e.g. an Internet router) via the Ethernet
port.
Installation and maintenance instructions VPV I 0020273427_02
.