Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. MOUNTING THE WHEELS TO THE LEGS
Parts Required:
2
x
Support Leg (#14)
2
x
Wheel (#16)
2
x
Wheel Axle Pin (#G)
Wheel Axle Washer (#F)
2
x
Wheel Cotter Pin (#E)
2
x
Installation:
•
Attach the wheel to the support leg by inserting the wheel axle pin
through the wheel, support leg, wheel axle washer, then secure using
the wheel cotter pin.
•
Repeat installation for the other wheel and support leg.
2. MOUNTING THE LEGS TO MAIN BARREL
Parts Required:
1
x
Main Barrel / Hopper Assembly (#9)
2
x
Stationary Support Leg (#13)
2
x
Support Leg (#14)
Screw (#A)
16 x
Locking Washer (#C)
16 x
16 x
Washer (#B)
Installation:
•
Place a piece of cardboard on the floor to prevent scratching the unit.
Lay the main barrel on its side, hopper end pointed upward, on the
cardboard. Note illustration.
•
Mount one support leg to the floor end of the main barrel using four
screws, locking washers, and washers, through the four pre-drilled
holes. Repeat installation for second support leg.
ASSEMBLY PREPARATION
ASSEMBLY INSTRUCTIONS
1
G
16
14
F E
2
C B
A
13
13
A C B
14
14
7