BH FITNESS G246 Instrucciones De Montaje página 15

5. FITTING THE ELECTRONIC
MONITOR.-
Mod. G-246.-
Bring the monitor
handlebar stem (11) Fig.8, connect
the terminal (15) coming out of the
handlebar stem (11) and the monitor
(145), Fig.8.
Take hold of the Hand-grip connector
(147), sticking out of the main post 11,
and plug it into located at the back of
the monitor (145), as shown in Fig.8.
Insert the monitor (145) onto the
handlebar stem (11), as shown in
Fig.8, making sure not to pinch any of
the cables. Fit the bolts (13) along with
the fl at washers (14, 12), making sure
that the handlebar is aligned correctly,
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 2.
Mod. G-247N.-
Bring the monitor
handlebar stem (11) Fig.9, connect
the two terminals (18 / 20) coming out
of the handlebar stem (11) and the
monitor (151), Fig.9.
Take hold of the Hand-grip connector
152, sticking out of the main post 11,
and plug it into located at the back of
the monitor (151), as shown in Fig.9.
Insert the monitor (151) onto the
handlebar stem (11), as shown in
Fig.9, making sure not to pinch any of
the cables. Fit the bolts (13) along with
the fl at washers, making sure that the
handlebar is
securely tighten all of the bolts on the
(145) to
(151) to
aligned correctly,
handlebar stem including the bolts at
the base which were left hand tight in
point 2.
LEVELLING.-
the
Once the unit has been placed into its
fi nal position, make sure that it sits fl
at on the fl oor and that it is level. This
can be achieved by screwing the
adjustable feet (Y) up or down, as
shown in Fig.10.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (W),
as shown in Fig.11, which make it
easier to move. The two wheels at the
front of the unit make it easier to place
the unit in to any chosen position by
lifting the rear slightly
Store your unit in a dry place,
preferably not subject to changes in
temperature.
ATTENTION: It is advisable to
retighten these screws after one
the month of using the machine.
MAINS CONNECTION.-
Insert the jack for the transformer into
the connection hole on the main body
(bottom, rear of the machine) and then
plug the transformer (138) into a 220
V mains supply, Fig.12.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
15