Status Functions - Promax MO-180 Manual De Usuario

Gateway IP
4-byte IP address of the gateway that resolves IP addresses which are not
within the subnet. Defaults to 0.0.0.0 (not used).

4.12 STATUS functions

These functions provide information about errors, parameters extracted from
the MIP or input TS, software and firmware versions, and SFN synchronisation status.
Error List
During the continuous operation of the MO-180, the first 16 errors detected are
stored as a reference to identify problems. Usually, no errors are generated, and the
display should be as follows:
MENU: back PUSH: select TURN: next/prev.
NO ERRORS
But, during operation, two different kinds of errors are possible (see Section
4.15 for further information):
Errors generated when the modulator is not locked.
These are usually temporary errors related to input transport stream transitions
or invalid TS bit rates.
Errors generated due to a circuit failure. When this kind of errors persists, the
instrument must be serviced in a PROMAX official centre.
See section 4.15 for an explanation of the format used to display the errors.
Clear Errors
Select this function to clear the internal error counter and errors list explained
formerly. The possible selections are YES and NO.
SW/FW/OPT
Indicates the software version (SW), fimware version (FW) and options currently
enabled in the modulator. For instance, the following display
MENU: back PUSH: select TURN: next/prev.
STATUS SW/FW/OPT: v1.6.29 — 89.01 - _HSF
corresponds to software version 1.6.29, firmware version 89.01 with options DVB-H,
SFN and PID filtering installed and enabled.
Page 38
USER'S MANUAL MO-180
04/2008