Pediatric Pro Elevating Leg Rest - Ki Mobility Little Wave FLIP XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
L. Pediatric Pro Elevating Leg Rest
Installation
NOTE: The Pediatric Pro ELR is mounted onto the chair the same way as a swing away hanger.
1. Place swing away pivot saddle into the receiver on front frame tube with the leg rest facing
either inward or outward from the frame.
2. Rotate the leg rest so that it aligns with the frame and locks into place in the latch block.
Adjusting Height of Calf Pad
1. Loosen nut (Fig. 23:D) using a 10mm wrench.
2. Slide calf pad arm up or down to desired location.
Retighten nut.
Adjusting Depth of Calf Pad
1. Remove screw (Fig. 23:C), washer (Fig. 23:B) and
nut (Fig. 23:A) on calf pad arm using a 5mm Allen
wrench and a 13mm wrench.
2. Pick the desired location based on the four
predrilled holes and reinstall screw and nut.
Adjusting Knee Height
1. Using two 10mm socket wrenches,
loosen the two nuts (Fig. 24:A) on the
cover.
2. Adjust knee height to desired setting.
3. Retighten the two nuts (Fig. 24:A) after
desired height is attained.
Use
1. To raise the Pediatric Pro ELR, lift the leg
rest tube (Fig. 25:A) to desired angle of
elevation.
2. To lower the Pediatric Pro ELR, press and
hold the lever lock (Fig. 25:B) while
pushing the leg rest tube (Fig. 25:A) down.
NOTE: Remove the Pediatric Pro ELR from
the chair or remove weight from the Pediatric
Pro ELR while lowering to avoid a sudden drop
when the lever lock is pushed.
NOTE: The calf pad can swing outward to
clear the front of the chair for transfers.
Removal
1. To remove leg rest, push or pull release
latch.
2. Lift the leg rest straight upward to remove.
You may also swing the leg rest inward or
outward before lifting it off.
Fig. 23
A
B
Fig. 24
Fig. 25
A
27
1½" range
of motion
A
B
D
C