Briggs & Stratton Allmand NIGHT-LITE GR Serie Manual Del Operario página 15

11
3. Make the light tower trailer level using the tongue jack.
See Operating the Tongue Jack in the Transporting
section.
4. Deploy the outriggers. See Operating the Outriggers.
5. Make the light tower trailer level front to back and side to
side using the jacks.
Operating the Outriggers
The unit has left and right outriggers at the rear of the
machine.
WARNING
Rollover Hazard
• Failure to deploy the outriggers before raising the light
tower could cause the light tower trailer to tip over,
resulting in death or serious injury. Always deploy the
outriggers before raising the light tower.
• Failure to lock the stabilizer jack in the operating
position could cause the back of the light tower trailer to
fall, resulting in death or serious injury. Always be sure
to lock the stabilizer jack in the operating position with
the jack locking pin.
• Stabilizer jacks must be supported by a flat, level solid
ground surface.
To deploy the outriggers:
1. Pull the outrigger locking pin (A, Figure 12).
2. Move the outrigger (B, Figure 12) out until the pin locks
the outrigger in the operating position.
When initially shipped from the factory, the outrigger
jacks are toward the front of the machine (not shown) for
shipping purposes. They should be toward the rear of
the machine as shown in Figure 12. Move the outrigger
completely out, turn the outrigger so the jack is toward the
rear of the machine, and install, making sure that the pin
locks the outrigger in the operating position.
3. Remove the stabilizer jack locking pin (C, Figure 12), turn
the jack into the operating position (D), and install the
stabilizer jack locking pin fully through the top and bottom
holes in the jack and outrigger.
4. Unfold the handle (E, Figure 13) of the stabilizer jack,
then turn clockwise (F) to lower the jack foot (G) until
firmly planted on the work site surface.
5. Repeat for the opposite outrigger and stabilizer jack.
To retract the outriggers:
1. Fully lift the stabilizer jack foot by turning the jack handle
counterclockwise.
2. Fold the handle.
3. Remove the stabilizer jack locking pin, turn the jack
into the transport position, and install the stabilizer jack
locking pin fully through the top and bottom holes in the
jack and outrigger.
4. Pull the outrigger locking pin, and move the outrigger in
until the pin locks the outrigger in the transport position.
5. Do the same for the other stabilizer jack and outrigger.
12
15