SICE S 200 Manual De Instrucciones página 94

and cause a fire.
• Make sure that the cable is positioned so that it cannot be pulled and the risk of tripping
is avoided.
9. Risk of eye injuries.
During the bead insertion and inflation phase, debris, dust and fluids
could be projected into the air. Remove any debris from the tyre tread
and on the tyre surface. Wear OSHA approved safety glasses during
mounting and demounting procedures.
10.Always carefully inspect the machine before using it. Missing, damaged
or worn equipment (including the hazard adhesive labels) must be repaired or replaced
before start-up.
11.Never leave nuts, bolts, tools or other materials on the machine. They could be entangled
in moving parts and cause malfunctions.
12.NEVER install or inflate cut, damaged, rotten, or worn tyres. Do NOT mount tyres on
damaged, bent, rusted, worn, warped or deformed rims.
13.Should the tyre get damaged during the mounting phase, do not attempt to complete the
mounting operation. Remove it, take it away from the service area and mark it as damaged.
14.Inflate the tyres in gradual steps, while continuously monitoring the pressure and
observing the tyre, the rim, and the bead. NEVER exceed the pressure limits indicated
by the manufacturer.
15.The internal parts in this equipment could create contacts or sparks if exposed to
flammable vapours (petrol, paint thinners, solvents, etc.). Do not install the machine in
a narrow area or position it below floor level.
16.Do not operate the machine while under the influence of alcohol, medicines and/or
drugs. If you are taking prescription or non-prescription medicines, contact a physician
to be aware of the side effects that they might have on the ability to operate the
machine safely.
17. Always use OSHA approved and authorised personal protective equipment (PPE)
while operating the machine. Consult your supervisor for additional instructions.
18.Do not wear jewellery, watches, loose clothing, ties and tie up long hair before using
the machine.
19.Wear protective, non-slip footwear while using the tyre changer.
20.While positioning, lifting or removing wheels from the tyre changer, wear an appropriate
back support and use a correct lifting technique.
21.Only appropriately trained personnel can use, service and repair the machine. Repairs
must only be performed by qualified personnel. Your Hunter service representative is
the most qualified person. The employer must determine if an employee is qualified
to carry out any machine repair safely if the operator has attempted to make the repair.
22. Before starting the machine, the operator must pay close attention to the warnings
of the adhesive labels affixed to the equipment.
94 Manuale d'uso S 200