Ottobock 6A30-20 Instrucciones De Uso página 18

3) Screw the set screw into the shuttle lock on the inside of the prosthetic
socket (torque value: 0.5 Nm). This secures the ratchet unit (see fig. 13).
6 Use
CAUTION
Pin not fully inserted into the lock
Risk of injury due to loss of connection to the prosthesis
► Guide the pin into the lock in accordance with the instructions.
► Always verify that the pin is engaged in the lock before using the pros­
thesis.
The liner and shuttle lock are connected to each other with the pin. The pin
engages in the shuttle lock and holds the liner in place.
Putting on the Liner
1) Check the pin and liner for damage.
2) NOTICE! Align the pin with the longitudinal axis of the residual
limb to prevent damage.
Roll up the liner and place it on the end of the residual limb.
3) Unroll the liner onto the residual limb so that it has no wrinkles, without
shifting the soft tissue.
4) Check the fit and the alignment of the liner.
Donning the Prosthetic Socket
1) Slide into the prosthetic socket with the liner until the pin slides into the
opening of the shuttle lock.
2) Insert the pin fully into the shuttle lock.
3) Before using the prosthesis, verify that the pin is fully engaged in the
shuttle lock.
Doffing the Prosthetic Socket
► Press and hold the side button and pull the residual limb with the liner
out of the prosthetic socket.
7 Maintenance
► A visual inspection and functional test of the prosthetic components
should be performed after the first 30 days of use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
18