Maintenance; Care; Changing Filters - Kemper SmartFil Instrucciones De Servicio

7 Maintenance

The instructions in this chapter are intended as minimum requirements. Depending on the
operating conditions, further instructions may be required to keep the product in optimal
condition.
The maintenance and repair work described in this chapter must only be performed by
specially trained repair personnel of the operating company.
Spare parts used must comply with the manufacturer's specified technical requirements.
This is guaranteed if original spare parts are used.
The safe and environmentally friendly disposal of operating materials and replacement
parts must be ensured.
The safety instructions in these operating instructions must be observed during
maintenance work.

7.1 Care

The care of the product is essentially limited to cleaning all surfaces of the product and – if
present – checking the filter inserts.
The warning notices listed in the chapter "safety notes for maintenance and fault removal
on the product" must be observed.
NOTE
The product may not be cleaned with compressed air. This may result in dust and/or dirt
particles getting into the ambient air.
Proper care helps to maintain the product in a continuous functional state.
• The product must be cleaned once a month.
• The exterior areas of the product can be cleaned with a suitable industrial vacuum
cleaner of dust classification H or alternatively wiped with a wet cloth.
7.2 Maintenance
Regular inspection and servicing have a positive effect on the reliable functioning of the
product and should be carried out at least once a year.
The device operates maintenance-free except for the necessary filter replacements.
Observe the warning notices for servicing and troubleshooting in the "Safety" chapter.

7.3 Changing filters

The life of the filter inserts depends on the type and amount of deposited particles.
As the dust accumulation in the filter increases, its flow resistance increases and the
extraction capacity of the product decreases. A filter change is now required.
1502818-00 - 55 -
EN