Using The Cooktop; Control Knobs; Operation Of The Burners - Thermador PC364GE Manual De Instrucciones

Section 4: USING THE COOKTOP
Sealed Burners
Sealed Star® Brass
Burner Base
The cooktop features four or six
gas surface burners; each rated
at 15,000 BTU/HR using natural
gas (13,000 BTU/HR using
propane). The burners are sealed
to the stainless steel top frame to
prevent liquid spills
accumulating below the top
surface, making it easier to clean.
On all models, the two left burners
have the exclusive ExtraLow
feature, the remaining burners are
standard. Each burner has its own
control knob.

Using The Cooktop

CONTROL KNOBS

The control knobs for two sealed
gas burners, one in front and one
in the rear, are located directly in
front of and below the pair of
burners on the control panel.
Setting Indicator
Knob
Standard Burner
from
Control Knob
The two words above each control
knob identifies the burner
position. For example, LEFT
FRONT, RIGHT FRONT, etc.
OPERATION OF THE
BURNERS
• Press in on the knob and turn it
counter-clockwise to the HI
setting.
• The igniter for the selected
sealed burner clicks and
sparks.
• After flame ignition, the igniters
stop clicking.
• Rotate the knob to any flame
setting between HI and LO.
• The Blue Burner Signal Light,
between the burners, will light
when adjacent burners are lit.
They will remain on until the
burner is turned off.
BTU Output for Standard
Burners
• HI is equivalent to 15,000 BTU /
HR using natural gas (13,000
BTU / HR using propane).
• LO is equivalent to 2,100
BTU / HR.
BTU Output for ExtraLow®
Burners
• HI is equivalent to 15,000 BTU /
HR using natural gas (13,000
BTU / HR using propane).
• LO is equivalent to 3,000
BTU / HR.
• XLO is equivalent to 370
BTU / HR.
ExtraLow® Burners
The controls for the two left
burners, front and rear, have flame
settings even lower than the
standard LO settings.
ExtraLow
Range
The drawing shows that the
control knob has an additional
range between the LO and XLO
settings. When the knob is set
within this range, the flame cycles
off and on. By varying the length
of time the flame is off and on,
the heat is reduced even further
to cook delicate foods. For
example, these very low settings
are suitable for simmering and
poaching, melting chocolate and
butter, holding cooked foods at
temperatures without scorching or
burning, etc.
9
Setting Indicator
®
ExtraLow® Burner
Control Knob