edenox DNU Manual De Instrucciones página 14

5. TROUBLE-SHOOTING
5.1 Trouble-shooting information.
5.1 TROUBLE-SHOOTING INFORMATION.
IMPORTANT!!!
Electrical subassemblies may be replaced only by an authorised service technician.
It must be made a principle to disconnect the power cable from the power supply before
electrical components are replaced.
It must be made a principle to disconnect the power cable from the power supply before
electrical components are replaced.
FAULT
The top extension emits no light
(no heat).
The guarantee does not cover the following:
Bulbs, rubber elements, heating elements damaged by boiler scale, panes, any mechanical
damage or any damage caused by improper use of the device in violation of the instructions.
In case of a fault, remove the food kept in the device to prevent it from going bad. EDENOX
is not responsible for any commodities wasted as a result of a fault.
9
edenox.com
POSSIBLE CAUSE
- Power supply failure.
- The terminals of the conductors
loosened on the power strip.
- Some lighting (heating) elements
are disconnected.
- Damaged switch.
- Lamp burnt out.
ENGLISH
REMEDY
Connect to power supply.
Appropriately fix the conductors to
the power strip.
Check the connection of the
lighting (heating) elements.
Replace the damaged components.
Replace the lamps with new ones.