Error handling
Automig Pulse has a sophisticated built-in self-protection system. The machine automatically stops the gas supply, interrupts the welding
current and stops the wire feeding in case of an error.
Selected errors:
Gas control error (IGC)
A gas control error can be due to too low or too high gas flow.
Check that the pressure of the gas flow is higher than 2 bar and lower than 6 bar, corresponding to 5 l/min and 27 l/min.
Correct the gas error by adjusting the manual gas flow to 27 l/min. Reset the the gas error by briefly pressing the
Error log
I
III
II
IV
Error log
All errors are saved in the
machine error log in the menu
Service.
The error log can be
distributed, when inserting
a SD-card and pressing the
following key:
The error log is now saved at
the SD-card.
The error log can be reset
when pressing the key pad
with the trash bin
.
16
P
-key.