Driver Installation; Using With Databases; Noah 4; Standalone Version - Interacoustics Affinity 2.0 Manual De Instrucciones

2.5

Driver installation

Now that the Affinity 2.0 / Equinox 2.0 Suite software is installed, you must install the driver for the
hardware.
1. Connect the Affinity 2.0 / Equinox 2.0 hardware to the PC via the USB connection.
2. The system will now automatically detect the hardware and display a pop-up on the bottom right of the
task bar. This indicates that the driver is installed and the hardware is ready for use.
2.6

Using with databases

2.6.1

Noah 4

If you are using HIMSA's Noah 4, the Affinity software will install itself automatically in the menu bar on the
start page, along with all the other software modules.
Working with OtoAccess®
For further instructions about working with OtoAccess®, please see the OtoAccess® operation manual
2.7

Standalone version

If you do not have Noah on your computer you can directly launch the software suite as a stand-alone
module. However, you will not be able to save your recordings when using this way of working.

2.8 How to configure an alternative data recovery location

The Affinity Suite has a backup location for data to be written in the case that the software is accidentally
terminated or the system crashes. The following locations are the default storage folder for recovery or
standalone databases C:\ProgramData\Interacoustics\Affinity Suite\ or
C:\ProgramData\Interacoustics\Equinox Suite\ but they can be amended via the following instructions.
NOTE: This feature can be used to change the recovery location when you are working through a database
as well as the standalone save location.
1. Go to C:\Program Files (x86)\Interacoustics\Affinity Suite or C:\Program Files
(x86)\Interacoustics\Equinox Suite
2. In this folder find and launch the executable program titled FolderSetupAffinity.exe or
FolderSetupEquinox.exe
3. The below pop up will appear
Affinity2.0 – Instructions for Use - EN Page 24