BM2 BIEMMEDUE DUSTY 1100 ET Manual De Uso Y Mantenimiento página 27

7.7.2 Controls alongside the seat
brush
swithc
suction and
filter shaker
switch
emptying
switch
This panel incorporates the lever (foreground) to raise (lever
forward) and lower (lever backward) the central brush while the
machine is being moved and in operation respectively.
The panel also includes a three-position selector to shut off suction
and activate the filter shaker motor, vice versa, or shut off both. In
the central position, both suction and the filter shaker are off; when
the selector is moved forward, suction is activated and when the
selector is towards the back, the filter shaker is activated. An electric
motor with cam vibrates the filter, shaking off the dust which is
collected in the debris collection bin. While performing this
operation, suction must be off otherwise the dust shaken off the filter
by the vibration will be transported back to the filter by the air flow.
There is also a switch which activates (forwards, ON) or deactivates
(backwards, OFF) brush rotation. Deactivating brush rotation
savesenergy when moving the machine.
The display unit indicates the value of batteries charge in volt and
the eventual anomalies. The error messages are numbered (see
label applied on the electronic box inside of the sweeper.
7.8 Semi-automatic empying (PLUS version)
To use the semi-automatic emptying system, proceed as follows:
- park the machine on a flat level surface (NOT sloping)
- use lever A to position the tip-over supports.
- action deviator B on the side panel until the bin is fully raised
- place an appropriate container under the bin to collect the debris
- with one hand hold handle C firmly and with the other action lever
D
display
central brush
lever
- rotate the bin to empty it
- put the bin back in the original position (automatic catch)
- remove the container with the debris
- action deviator B until it is fully closed
- raise the tip-over supports
IMPORTANT: during opening and closing manoeuvres, keep hands
and objects away from the sliding and raising zones.
NEVER exaggerate with the weight and volume of the debris. Empty
frequently to avoid clogging and blocking the opening system.
Keep the area of the machine where the bin rests
(gaskets) clean to guarantee correct closure.
7.9
The following pictograms are used on the machine.
7.10
The following pictograms are used on the machine.
Pictograms on the petrol engine model
controls
Danger of contact with acid or corrosive substances in the
battery.
The symbol is located inside the seat cowling.
No naked flames.
The symbol is located inside the seat cowling.
Risk of fire.
The symbol is located inside the seat cowling.
Risk of explosion.
The symbol is located inside the seat cowling.
Risk of burns.
The symbol is located on the side near the exhaust.
Cables and hooks must be used.
The symbol is located near the two hooks near the pedals
and the two hooks at the rear.
The machine must not be used on slopes of greater than
12%.
The symbol is located near the accelerator knob
Pictograms on the electric model controls
Danger of contact with acid or corrosive substances in the
battery.
The symbol is located inside the seat cowling.
No naked flames.
The symbol is located inside the seat cowling.