Clock Set - Airwell FAV012 Manual De Instrucciones

Parts and Functions
24.HIGN/SO Run Display
25.Code A of controller's state
Code A is used for the units in this manual.
26.SIGNAL SENDING Display
27.Code B of controller's state
28.Fresh Display
29.Auxiliary ELECTRICAL HEATING Display
30.HEALTH Display
Displays when healthy run function is set.
31.Operation MODE Display
AUTO RUN COOL RUN DRY RUN HEAT RUN FAN RUN
32.SLEEP State Display
33.LOCK State Display
34.FAN SPEED Display
Code A
LOW
MID
35.TIMER ON Display
36.HEAT Button
Used to select auxiliary heater function.
Note:
1.Models in this manual have no functions
5 8 11 14 16 17 21 24 27 28 29 30 36
2.HIGH/SO button
This button is active in Cooling/Heating mode,
the fan speed is in AUTO mode after pressing
it and "high functon" will be automatically
cancelled after 15 minutes running.
Remote Controller Operation
When in use, direct signal transmission head to
the receiver placed on the indoor unit.
The distance between the remote controller and
the receiver should be max 7m and there should
be no obstacle between them.
Do not throw the remote controller to prevent it
from being damaged.

Clock Set

When the unit is started for the first time or after replacing batteries in remote controller,
clock should be adjusted as follows:
1.Press CLOCK button, clock indication of " AM " or " PM " flashes.
2.Press " " or "
by 1 min. If the button is kept pressed, the time will increase or decrease quickly.
3.Press "SET" button to confirm the time setting. AM or PM stop flashing, while clock starts
working.
Note:AM means morning and PM means afternoon.
A
U
T
O
HIGH AUTO
" to set correct time. Each press the time will increase or decrease
When operating the remote controller in an area where
electronically controlled lights are installed or wireless
handsets are used, please move closer to the indoor
unit as the function of the remote controller might be
affected by signals emitted by the above
mentioned equipments.
Battery loading
Batteries are fitted as follows:
Remove the battery compartment lid
Slightly press and disengage the battery compartment
lid marked with " " and then hold the remote controller
by the upper section and then remove the battery
compartment lid by pressing in the direction of the arrow
as shown in the figure above.
Loading the battery
Ensure that batteries are correctly placed in the
compartment as required for positive and negative
terminals.
Replacing the battery compartment lid
The battery compartment lid is reinstalled in the reverse
sequence.
Display review
Press the button to see if batteries are properly fitted.
If no display appears, refit the batteries.
Confirming indicator
If no indication is displayed after press ON/OFF button,
reload the batteries.
Caution: if the remote controller does not operate as
designed after fitting new batteries of the same type,
press the Reset button (marked ) with a pointed article.
Note:
It is recommended that the batteries should be removed
from the compartment if the remote controller is not used
for an extended period.
The remote controller is programmed for automatic test
of operation mode after the batteries are replaced. When
the test is conducted, all icons will appear on the screen
and then disappear if the batteries are properly fitted.
When throw away the waste batteries, please perform
in accordance with the local regulation.
6
MODE SLEEP
HEALTH FRESH
CLOCK SET
3
1 TIMER 2 HIGH/SO
FILTER
HEAT
LIGHT LOCK
RESET CODE