Airwell FAV012 Manual De Instrucciones página 22

Operation instruction
AUTO, COOL , HEAT and DRY Operation
TEMP
ON
3
OFF
SWING
5
MODE
HEALTH FRESH
2
CLOCK
TIMER
FILTER
LIGHT
RESET CODE
COOL operation starts
when room temp.is higher
than temp. setting.
Temp. setting +2 C
Temp.setting
On reaching temp.setting
+2 C, unit will run in mild
DRY mode.
3
FAN
1
4
SLEEP
SET
HIGH/SO
HEAT
LOCK
Ultra-low air flow
(1) Unit start
Press ON/OFF button, the unit starts.
Previous operation status appears on LCD (except for
TIMER,SLEEP and SWING setting)
(2) Select operation mode
Press MODE button. Each press, the operation mode
changes as follows:
Code A
AUTO COOL DRY
Then select AUTO, COOL, DRY or HEAT as needed.
(3) Temperature setting
Press TEMP button.
Every time the button is pressed, the setting temperature
increases by 1 C; if the button is kept pressed, the
setting temperature will increase quickly.
Every time the button is pressed, the setting temperature
decreases by 1 C, if the button is kept pressed, the
setting temperature will decrease quickly.
Set the proper temperature.
(4) Adjust fan speed
Press FAN button. Each press, the fan speed changes
as follows:
Code A
A
U
T
O
AUTO LOW
Air conditioner will run at the selected fan speed.
(5) Unit stop
Press ON/OFF button, the unit stops.
NOTE:
In FAN mode, the temperature setting is not displayed
on LCD.
In DRY mode, when room temperature becomes
2 C higher than temperature setting, unit will run
intermittently at LOW speed regardless of FAN setting.
When room temperature is lower than temperature
setting, unit will only run FAN operation.
In HEAT mode, warm air will blow out after a short
period of time due to cold-draft prevention function.
14
HEAT FAN
MID HIGH