Airwell FAV012 Manual De Instrucciones página 25

Operation instruction
Timer ON/OFF Function
TEMP
ON
OFF
SWING
1
MODE SLEEP
HEALTH FRESH
CLOCK
3
TIMER
2
FILTER
LIGHT
RESET CODE
Hints:
After replacing batteries or if a power failure occurs, TIMER setting must be reset.
Remote controller has memory function. When you use TIMER mode next time, just press SET
button after mode selection if timer setting is the same as the previous one.
(1) Unit start
After unit start, select your desired operation mode
(operation mode will be displayed on LCD).
(2) TIMER mode selection
Press TIMER button on the remote controller to change
TIMER mode. Every time the button is pressed, display
of TIMER mode changes as follows:
FAN
Then select TIMER mode as needed (TIMER ON or
TIMER OFF). Now
(3) TIMER setting
SET
Press time adjustment buttons
4
HIGH/SO
HEAT
LOCK
If the button is kept pressed, the time will changes
quickly.
It can be adjusted within 24 hours at will.
(4) Confirm setting
After setting correct time, press SET button to confirm
time. Now
Time displayed: unit starts or stops at X hour X min
(TIMER ON or TIMER OFF)
(5) Cancel TIMER mode
Just press TIMER button several times until TIMER
mode disappears.
Set clock correctly before starting TIMER operation.
ON OFF
AM
12:00 12:00
PM
TIMER ON TIMER OFF
ON
Every time the button is pressed, the time increases
by 10 minutes.
Every time the button is pressed, the time decreases
by 10 minutes.
or
ON OFF
17
blank
ON OFF
AM
12:00 12:00
PM
TIMER ON-OFF
or OFF will flash.
stop flashing.