Airwell FAV012 Manual De Instrucciones página 35

Installation Procedures
1. Take down wire controller from the holder
MODE FAN SWING
MODE FAN CENTRAL
AUTO AUTO OPERATION
HEALTH TEMP
FAN ONLY HIGH STANDBY
COOL MED PRE-HEAT
DRY LOW DEFROST
HEAT FIX FILTER
TES
CLOCK TIME
HEALTH CHECK SWING
UNIT NO. DEMAND MANUAL
CEN. ADD. ROOM TEMP.
TIMER SET RECOVERY
SYS. ADD. SET TEMP.
CLOCK UP DOWN VENTILATION
TIMER
ON AUTO
CHECK FILTER
OFF RECOVERY
RESET
DAILY NORMAL
ON/OFF
2. Install the controller holder
According to the position of 2 screw holes on the holder, drill 2 holes on the wall, and strike the
wood stopper to the holes respectively.
Then align the 2 screw holes of wired controller holder to the wood stopper, fix the holder on the
wall with wood screw.
Note:
Try a wall as flat as possible for installation. Don't use excessive force to tighten screws,
otherwise, the holder will be damaged.
3.Wiring instruction
Use shielded wire between indoor and wire controller. And be earthed on one side, or the unit
will not work normally because of interference.
shielded wire
grounding
Note:
Confirm the terminal connection firmly, and do not get in tough with shielded wire.
Don't touch the PC panel with your hands.
4.Place wire controller on the holder, and pay attention not to pressing any wires.
Wire controller
Bracket
Screw holes
27
52 0.2
Screw holes