Lincoln Electric SAF-RPO PRESTOMIG 185MP Manual De Instrucciones página 7

If the push-button is pushed in GMAW process in, the
output terminals will lived.
WARNING
During SMAW process, the output terminals are still
lived.
4. Knob Control: Depending on welding process, this
knob controls:
GMAW Inductance: Arc control is
process controlled by this knob. If the
value is higher, the arc will be
softer and during welding is less
spatters.
SMAW ARC FORCE: The output
process current is temporarily increased
to clear short circuit connections
between the electrode and the
workpiece.
5. WFS/Hot Start Control: Depending on welding
process, this knob controls:
GMAW Wire feed speed WFS: Value in
process percentage of nominal value
wire feed speed.
SMAW HOT START: Value in
process percentage of nominal value
welding current during arc start
current. The control is used to
set the level of the increased
current and arc start current is
made easy.
6. Welding Load Voltage / Current Knob Control:
Depending on welding process, this knob controls:
GMAW The welding load voltage and
process set by this knob [6] (also during
welding).
SMAW The welding current is set by
process this knob [6] (also during
welding).
7. EURO Socket: For connecting a welding gun (for
GMAW / FCAW-SS process).
8. Positive Output Socket for the Welding
Circuit: For connecting an electrode
holder with lead / work lead.
9. Negative Output Socket for the Welding
Circuit: For connecting an electrode
holder with lead / work lead.
10. Left Knob: The value of parameter in the upper left
side of display [13] is adjusted.
11. Right Knob: The value of parameter in the upper
right side of display [13] is adjusted.
12. Set Knob: Type of welding procedure and welding
settings is changed by this knob.
13. Display: Parameters of welding process are shown.
14. User Button (left): Button function could be set:
English

Advanced menu:

Recalls advanced menu (default)

Recalls user memory.

Inductance.

Run-in WFS.

Burnback.

Basic menu – changes basic menu for advanced
menu.
15. Escape Button (right):

Cancels an action / exit menu.

Locks and unlocks knobs and buttons on the panel
(press and hold button for 4 seconds).
16. Power Switch ON/OFF (I/O): Controls the input
power to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I"). After input power is connected and the
power switch is turned on, the indicator will light up to
indicate the machine is ready to weld.
17. Gas Connector: Connection for gas line.
4
Figure 2.
Figure 3.
English