Maintenance - EdilKamin IDROSALLY Instalación Uso Y Mantenimiento

MAINTENANCE

Before performing any maintenance, disconnect the applian-
ce from the mains.
Regular maintenance is required for the boiler-stove to fun-
ction correctly.
Any problems resulting from lack of maintenance will imme-
diately void the warranty.
3
When cleaning is necessary, the message "Clean - exchan-
ger" will appear on the panel if further cleaning is necessary.
1
NOTE: The DEALER, upon commissioning, sets the kg va-
lue of consumed pellets; after which, the message "SERVICE
UTE" will appear on the display. The boiler-stove continues
operation, but the end client is invited to perform careful
maintenance, described above and explained by the DEA-
LER during commissioning, to the extent of his abilities.
2
Once the maintenance work has been performed, press and
hold down the "M" button on the radio remote control for at
least 5 seconds to delete the message displayed on the screen
(this operation must be performed with the thermo-stove
off).
N.B.
- Any unauthorised modi cation is forbidden
fi g. A
- Use spare parts recommended by the manufacturer
- The use of counterfeit parts results in the guarantee beco-
ming null and void
DAILY MAINTENANCE
Operations must be performed when the boiler-stove is off,
cold and unplugged from the power supply.
Cleaning should be carried out with the aid of a vacuum clea-
ner (see optional page. 60), the whole procedure takes up a few
minutes.
*
• Open the door, remove the combustion chamber (1 - g. A) and
empty the residue out into the ash pan.
• Scrap the combustion chamber with the spatula provided,
removing any obstructions in the openings.
• DO NOT EMPTY THE RESIDUE OUT INTO THE PEL-
LET HOPPER.
• Take out and empty the ash (2 - g A) pan into a reproof con-
tainer (the ash may still contain hot parts and/or embers).
• Vacuum clean the inside of the replace, the re surface, the
compartment around the chamber where ash falls, and the ash
pan.
• Vacuum the combustion chamber holder, clean the edges where
the combustion chamber is lodged into its seat.
• Clean the glass, if necessary (when cold).
AT LEAST ONCE A DAY ACTION THE CLEANING
fi g. B
BRUSHES OF THE EXCHANGERS (*), EVEN WHILE
THE STOVE IS LIT, USING THE GLOVE PROVIDED:
- Proceed shaking the cleaning handle under the ceramic top (*
- g. B).
NEVER SUCTION HOT ASH, as this could damage the
suction device and possibly cause a re.
ATTENTION:
MAKE SURE THE ASH PAN IS CORRECTLY POSITIO-
NED IN ITS HOUSING (2 g. A)
WEEKLY MAINTENANCE
• Clean the hearth (with the tube brush).
• Vacuum the pipe near the electric coil (3 - g A).
- 54
-