Settings; Display; Stand By; Operation With Additional Thermostat Optional - Dal Zotto Leyla Elite Manual Del Usuario

SETTINGS

• DATE TIME
• LANGUAGE
• DEGREES

DISPLAY

This menu allows you to adjust the brightness of the display. The possible values go from OFF, 1 to 20. If OFF, the display backlight is at the
maximum intensity and goes out after a 60 second delay.
The backlight comes back on when a key is pressed or if an alarm is generated.
CONTROLS PROCEDURE
Š Press 6.
Š Press 3 until SETTINGS appears and con rm by pressing 6.
Š Keep pressing 3 until DISPLAY appears and con rm by pressing 6.
Š Use keys 4 -5 to set the desired intensity.
Š Press 6 to con rm or 1 to return to the previous menus to the initial state.

STAND BY

If enabled, the STAND BY function is used to switch o the machine from the additional thermostat
CONTROLS PROCEDURE
Š Press 6.
Š Press 3 until SETTINGS appears and con rm by pressing 6.
Š Keep pressing 3 until STAND BY appears and con rm by pressing 6.
Š Use keys 4-5 to enable (ON) / disable (OFF).
Š Press 6 to con rm or 1 to return to the previous menus to the initial state.
STAND BY FUNCTION ON
If the STAND-BY function is active (ON), if the room temperature exceeds the value of the SET THERMOSTAT + DELTA T OFF, then the stove
will switch o after a preset delay, displaying STAND BY.
When the room temperature is lower than the SET THERMOSTAT - DELTA T and after a possible cooling time, the stove switches back on.
STAND BY FUNCTION OFF FACTORY SETTING
If the STAND-BY function is not active (OFF ), if the stove exceeds the set room temperature it will switch to the minimum value, modulating
and displaying MODULATION. When the room temperature is lower than the SET THERMOSTAT the stove goes back to operating at the set
power, displaying WORK.

OPERATION WITH ADDITIONAL THERMOSTAT OPTIONAL

STAND BY FUNCTION OFF FACTORY SETTING
If the STAND-BY function is not active (OFF ), if the stove exceeds the room temperature set on the additional thermostat (contact open) it will
switch to the minimum value, displaying MODULATION. When the room temperature is lower than the value set on the additional thermostat
(contact closed), the stove goes back to operating at the set power, displaying WORK.
STAND BY FUNCTION ON
When the STAND-BY function is active (ON), when the room temperature set on the additional thermostat has been reached (contact open),
the stove will switch o after a preset delay, displaying STAND BY.
When the room temperature is lower than the value set on the additional thermostat (contact closed) and after a possible cooling time, the
stove switches back on.
FOR CORRECT OPERATION, SET THE SET THERMOSTAT TO LOW TA.
> SEE CHAPTER ON THE ADDITIONAL THERMOSTAT SETTINGS
ENGLISH
SEE CHAPTER: SETTINGS FOR FIRST USE
57