TO FIND OUT WHERE YOUR NEAREST SERVICE CENTRE IS, CONTACT YOUR DEALER OR GO TO THE WEBSITE:
CLEANING AND MAINTENANCE
ALWAYS FOLLOW THE INSTRUCTIONS IN COMPLETE SAFETY!
Make sure that the power cord plug is disconnected as the generator may have been programmed to turn on.
Make sure that all parts of the generator are cool.
Make sure that the ashes are completely cold.
Ensure su cient air renewal in the room while cleaning the product.
Poor cleaning will compromise correct operation and safety!
MAINTENANCE
For correct operation, the generator must undergo routine maintenance by a quali ed technician, at least once a year.
The periodic inspections and maintenance operations must always be performed by specialised, expert technicians who operate according
to current legislation and following the instructions given in this use and maintenance manual.
ONCE A YEAR, HAVE THE SMOKE EXHAUST SYSTEM, SMOKE DUCTS AND T SHAPED FITTINGS CLEANED, INCLUDING
THE INSPECTION CAPS AND ANY ELBOWS AND HORIZONTAL SECTIONS!
THE GENERATOR CLEANING FREQUENCY IS INDICATIVE! IT DEPENDS ON THE QUALITY OF THE PELLET USE AND ON
HOW OFTEN IT IS USED.
SOMETIMES THESE OPERATIONS MUST BE PERFORMED MORE OFTEN
PERIODICAL CLEANING BY THE USER
The periodic cleaning operations, as indicated in this use and maintenance manual, must be performed with the utmost care after reading the
instructions, procedures and frequency described in this use and maintenance manual.
CLEANING THE SURFACES AND COATING
Never use abrasive or chemically aggressive detergents for cleaning!
The surfaces must be cleaned when the generator and coating are completely cold. For the maintenance of the surfaces and metal parts,
simply use a cloth dampened with water or with water and neutral soap.
Failure to comply with these instructions may damage the surfaces of the generator and result in the invalidation of the warranty.
CLEANING THE CERAMIC GLASS
Never use abrasive or chemically aggressive detergents for cleaning!
The ceramic glass must only be cleaned when the glass is completely cold.
To clean the ceramic glass, simply use a dry brush and some damp newspaper dipped in ash. If the glass is very dirty, use a speci c detergent
for ceramic glass. Spray a small amount on a cloth and use it on the ceramic glass. Do not spray the cleaning agent or any other liquid directly
on the glass or seals!
Failure to comply with these instructions may damage the surfaces of the ceramic glass and cause the invalidation of the warranty.
CLEANING THE PELLET HOPPER
When the hopper is completely empty, disconnect the generator power cord and remove the residues (dust, shavings, etc.) from the empty
hopper before lling it.
TO FIND OUT WHERE YOUR NEAREST SERVICE CENTRE IS, CONTACT YOUR DEALER OR GO TO THE WEBSITE:
60
WWW.LANORDICA-EXTRAFLAME.COM
WWW.LANORDICA-EXTRAFLAME.COM
ENGLISH