Grundfos CRE Instrucciones De Instalación Y Funcionamiento página 25

The functions of the two indicator lights and the signal relay are as shown in the following table:
Indicator lights
Operation
Fault (red)
(green)
Off Off
Permanently
Off
on
Permanently
Off
on
Off Flashing
Permanently
Off
on
Permanently Permanently
on on
Permanently
Flashing
on
Resetting of fault indication
A fault indication can be reset in one of the following ways:
• Briefly press the button or
change the setting of the pump.
A fault indication cannot be reset by means of
buttons have been locked.
• Switch off the power supply until the indicator lights are off.
• Switch the external start/stop input off and then on again.
• Use the R100. See section, 4.2.3 Fault
When the R100 communicates with the pump, the red indicator
light will flash rapidly.
Signal relay activated during:
Fault/Alarm,
Warning and Operating
Relubricate
C NO NC C NO NC
C NO NC
NO NC
C
C NO NC
NO NC
C
C NO NC C NO NC
C NO NC
NO NC
C
C NO NC C NO NC
C NO NC
C NO NC
on the pump. This will not
or if the
indications.
Description
Pump
Ready
running
The power supply has been switched off.
C NO NC
NO NC
C
The pump is operating.
C NO NC C NO NC
The pump is stopped by the stop
function.
C NO NC
NO NC
C
The pump has been set to stop.
C NO NC
C NO NC
The pump has stopped because of a
Fault/Alarm or is running with a Warning
or Relubricate indication.
If the pump was stopped, restarting will
be attempted (it may be necessary to
restart the pump by resetting the Fault
indication).
NO NC NO NC
C C
If the cause is "external fault", the pump
must be restarted manually by resetting
the Fault indication.
The pump is operating, but it has or has
had a Fault/Alarm allowing the pump to
continue operation or it is operating with
a Warning or Relubricate indication.
If the cause is "sensor signal outside
signal range", the pump will continue
operating according to the 70 % curve
and the fault indication cannot be reset
C NO NC C NO NC until the signal is inside the signal range.
If the cause is "setpoint signal outside
signal range", the pump will continue
operating according to the min. curve and
the fault indication cannot be reset until
the signal is inside the signal range.
The pump has been set to stop, but it has
been stopped because of a Fault.
C NO NC
C NO NC
25