Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IDENTIFICATION OF CONSTRUCTOR AND APPLIANCE
La targhetta di The nameplate shown here
is fi tted directly to the appliance. It contains
references and all essential information for
operating safety.
Extra nameplate
A)
a
) Country of use
1
a
) Appliance category
2
a
) Type of gas
3
a
) Gas pressure
4
a
)Type of fume exhaust vent
5
Nameplate
B)
b
) Appliance model
1
b
) Type of customisation
2
b
) Manufacturer identifi cation
3
b
) Serial number
4
b
) Protection class
5
b
) EC conformity mark
6
b
) Reference standard
7
b
) EC certifi cate number
8
b
) Product family type
9
b
) Type of gas
10
For all requirements contact the agents or the
headquarters of Angelo Po which can be found
in the contacts section of the website http://
www.angelopo.com.
When requesting service, state the data pro-
vide on the nameplate and provide a descrip-
tion of the fault.
3269870_ut_GB_rev.2
PROCEDURE FOR REQUESTING SERVICE
b
) Rated power (kW)
11
b
) Gas consumption
12
b
) Testing gas indicator frame
13
b
) Voltage (V)
14
b
) Frequency (Hz)
15
b
) Electricity power consumption (W)
16
b
) Test voltage indicator
17
b
) Date of construction
18
Testing gas plate
C)
c
) Type of gas
1
c
) Gas pressure
2
The installer must select the plate (A) and ap-
ply it alongside the nameplate relating to the
country of use, and must mark the relative ap-
pliance class (Type A = standard fume exhaust
vent).
If the appliance is to be used with the same
type of gas as used by the constructor for test-
ing, the installer has to remove the plate (C)
and apply the indicator (b13) against the data
of the gas for use on the nameplate.
- 3 -
GB
ENGLISH
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
