Safety Devices; Safety And Information Signs - Angelo Po 0N1FR1ID Manual De Uso

Even if the equipment has all its safety devices,
if necessary, during the installation and connec-
tion other safety devices may be supplemented
in accordance with applicable laws.
The illustration shows the position of the
devices.
Gas supply tap: for turning the connection to
A)
the gas supply line on and off .
Combustion control unit: cuts off the gas
B)
supply if the fl ame goes out.
Safety thermostat: cuts off the gas supply in
C)
case of overheating.
Importante Important
Make a daily check that the safety devices are
properly installed and in good working order.
The illustration shows the position of the signs
provided.
Nameplate with manufacturer and
A)
appliance data.
General hazard: read the manual carefully
B)
before carrying out any procedure.
General hazard: when washing the appli-
C)
ance do not point pressurised water jets at
internal parts.
General hazard: all relevant regulations
D)
must be complied with. "Install in compli-
ance with the relevant regulations and use in
well ventilated premises only".
General hazard: all relevant regulations
E)
must be complied with. "No liability is ac-
cepted in case of failure to comply with the
installation and commissioning instructions".
General hazard: watch out for hot surfaces.
F)
3269870_ut_GB_rev.2

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

- 5 -
C
B
C
B
E
D
C B
G
A
CE marking: this indicates that the
G)
equipment is compliant with all relevant laws
applicable to the product.
0N1FR*ID
0T1FR*ID
A
1N1FR2ID
1T1FR2ID
A
37M3202
ENGLISH
GB
F