Publicidad
The HPA control unit is supplied with its
Override code already customised: this is
noted on the "Factory code" sticker attached
to the control unit itself. This makes it possible
to avoid re-programming the code.
ATTACH the "Factory code" sticker onto the
OVERRIDE CARD supplied in the box (fig. 20).
Fig. 21
FINAL CHECK
After completing the installation and connecting the connector of the harness to the alarm control unit, close the
doors, bonnet, boot and windows and, proceed with the final check as follows, making sure that the vehicle keys
and remote controls are not inside the vehicle.
1. Reconnect the car battery; the central unit is disarmed;
2. Turn the car's ignition on to make sure the connections have been made correctly.
3. Arm the alarm control unit with the remote control by pressing button A: the central door locking locks the doors,
the protection of the alarm is armed, the direction indicators flash 2 times and the LED flashes.
4. During the 25 seconds entry time, make the following tests; the indicators will flash if they are completed
correctly:
• open a door, the bonnet and the boot;
• turn the ignition key to ON;
• insert your hand in the open window and move it forwards and back with respect to the ultrasonic
sensors;
each time the indicators flash, the entry time is reset and starts again.
5. After the initial entry time is over, the LED flashes at a slower rate and a 25 second alarm cycle will result if
any of the alarm protections are triggered: the siren produces its characteristic modulated sound, the direction
indicators flash and the horn, if connected, sounds intermittently. Check the correct operation of the engine
immobilisation during the alarm cycle.
6. Disarm the alarm control unit with the remote control by pressing button A: the central door locking unlocks the
doors, the direction indicators flash once, the siren makes 1 BOOP sound and the LED flashes to signal the
alarm memory. Refer to the installer's manual to decode the signal and for all the other features/settings of
the product (the manual can be downloaded from website www.metasystem.it).
11
OVERRIDE
CODE
Fig. 20
Publicidad
