To Replace The Fuses; To Connect The Jumper Cables; To Charge The Battery; To Do An Emergency Start Of The Engine - Husqvarna R 419TsX AWD Manual De Usuario

CAUTION: Spark plugs that are not
tightened correctly can cause damage to
the engine.
CAUTION: Do not try to start the engine
if the spark plug or ignition cable is
removed.

To replace the fuses

The fuses are put in 2 groups. The fuses for the mower
control module and the engine are in a holder in front of
the battery. The fuses for auxiliary electrical outputs are
in a holder in front of the hydraulic oil cooler. A blown
fuse is identified by a burned connector.
1. Open the engine cover.
2. Pull the fuse from the holder.
3. Replace the blown fuse.
4. Close the engine cover.
If the fuse blows again a short period after you replace
it, there is a short circuit. Repair the short circuit before
you operate the product again.

To charge the battery

• Charge the battery if it is too weak to start the
engine.
• Use a standard battery charger.
CAUTION: Do not use a boost charger
or start booster. That will cause damage
to the electrical system of the product.
• Always disconnect the charger before starting the
engine.

To do an emergency start of the engine

If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.
24

To connect the jumper cables

WARNING: Risk of explosion because of
explosive gas that comes from the battery.
Do not connect the negative terminal of the
fully charged battery to or near the negative
terminal of the weak battery.
CAUTION: Do not use the battery of your
product to start other vehicles.
1. Remove the engine cover.
2. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
3. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING: Do not short circuit the ends
of the red cable against the chassis.
4. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
5. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
6. Replace the covers.

To remove the jumper cables

Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
C
D
880 - 006 - 09.09.2020