To Adjust The Parallelism Of The Cutting Deck - Husqvarna R 419TsX AWD Manual De Usuario

5. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 4–6 mm (1/5") higher than the
front edge.
To adjust the parallelism of the cutting
deck
1. Park the product on hard level ground.
2. Apply the parking brake.
3. Move the weight transfer lever down.
4. Move the lift lever rearward and lift the cutting deck
to the transport position to engage the lift support.
5. Move the lift lever forward and lower the cutting deck
to the mow position.
6. Set the cutting height lever to the servicing position.
26
7. Remove the clevis joint on the front end of the height
adjustment stay. Move the height adjustment stay to
the side.
8. Loosen the locknuts on the lift stay.
9. Turn the adjustment nut on the lift stay to adjust the
length of the lift stay. Increase the length to lift the
rear edge of the cover. Decrease the length to lower
the rear edge of the cover.
10. Tighten the locknuts on the lift stay.
880 - 006 - 09.09.2020