Checking/Replacing Battery Of Receiver Collar - Num'axes CANICOM 200 Manual De Instrucciones

Ocultar thumbs Ver también para CANICOM 200:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 200 functions in safety mode and the system locks up. The
battery must be replaced.
Remove the old battery and replace it with a new battery (3-V Lithium CR 2430). Check the remote control
operates correctly.
- On the top of the remote control, unscrew the screw and the battery cover.
- Remove the old battery, using the special tab.
- Insert the new battery (3-V lithium CR 2430) making sure the polarity "+" noted on the battery is
visible (ref. Diagram 6). The tab is under the battery.
- Put the lid back in place, making sure the tab is in correct position (inside the battery housing) to
maintain water tightness.
- Put the top back, using the screw.
- Check the remote control operates correctly.
« + » of the battery
must be visible

Checking/Replacing battery of receiver collar

To check the condition of the receiver collar battery, observe the On/Off indicator located on the front of
the receiver collar:
Gb - 26
Diagram 6

Publicidad

Tabla de contenido
loading

Tabla de contenido