Setting Up The Iswitch; Setting Up The Receiver - Stryker iSwitch Manual De Operación Y Mantenimiento

Setting up the iSwitch

Setting Up the Receiver

1. Position the receiver on a Stryker cart or other sturdy platform.
2. Connect the AC Power.
• Connect the AC power cord to the AC input on the rear receiver
panel.
• Connect the other end to a hospital-grade receptacle.
3. Connect the devices that will be controlled by the footswitch System.
• For older TPS and SERFAS consoles, connect a device cable to the
appropriate port on the rear receiver panel, and then connect the
other end to the footswitch port on the front console panel.
• For newer CORE and SERFAS Energy consoles, connect a firewire
cable to the firewire port on the rear receiver panel, and then connect
the other end to the firewire port on the console rear panel.
Contact your local Stryker Representative for applicable device cable
part numbers.
Note When connecting devices to the footswitch receiver SFB serial
cable, connect the devices in series (see Figure 4 below).
Figure 4: Connecting devices in series to the footswitch receiver
4. Power on the receiver and all devices connected to it.
footswitch Receiver
TPS Console
SERFAS Console
Note Devices may also
be connected
directly to the
iSwitch Receiver.
8