Setting Up The Footswitch - Stryker iSwitch Manual De Operación Y Mantenimiento

Setting Up the Footswitch

1. Insert the Stryker Battery Pack (P/N 277-300-100).
It is recommended to use the Stryker Battery Pack to achieve
Note
maximum battery life and prevent improper insertion.
• Twist off the cap on the side of the footswitch by turning 1/2 turn
counterclockwise.
• Insert the batteries.
• Replace the cap and lock in place by turning 1/2 turn clockwise.
2. Synchronize the footswitch with the receiver.
• Press buttons I and III simultaneously and release.
• Align the footswitch synchronize logo with the footswitch 1
synchronize logo on the receiver.
• Hold the footswitch one inch away from the receiver. The LED will
appear red while synchronization is in process, and will change to
green when the footswitch has been synchronized.
3. Synchronize a second footswitch if needed.
• Press buttons I and III simultaneously and release.
• Align the second footswitch synchronize logo with the footswitch 2
synchronize logo on the receiver.
• Hold the footswitch one inch away from the receiver. The LED
indicator will change to green when the footswitch has been
synchronized.
Note A single footswitch cannot be synchronized to two channels.
4. Position the footswitch on the floor where it can be comfortably
accessed.
The Footswitch needs to be synchronized when a Receiver is
Note
powered on or when the Footswitch enters a new room. A
Footswitch is disconnected from the Receiver by powering off the
Receiver or pressing and holding the Receiver Mode button.
9