Use it when the battery is discharged (see warning light 3 f g.1) Proceed as belows:
- READ CAREFULLY THE OPERATIONS MANUAL 2 OF THE BATTERY CHARGER 1.
- take out the plug of the battery charger.
- make sure that the electric power supply is 220V.
- connect the plug of the charger to the socket of the electric power supply.
- the battery charger makes a self-checking before start, subsequently switches on the red light 3 and starts to recharge the battery.
During the charging operation the leds coming from:
Red 3 to Yellow 4 to Green 5.
The battery is completely charged when the green light 3 is "ON", the battery charger switches off automatically.
- disconnect the plug from the power supply and put it in the properly seating.
- check the battery electrolyte.
!
Warning!
For safety reasons the starting of the machine is excluded during the charging procedure.
The vacuum cleaner 1 is adapted to suck dust and little solid materials where the machine can not brushing, as
tight work areas, etc. The dirt is picked up to inside the paper sack 2. Replace the sack when it is nearly full
!
Warning!
The vacuum cleaner is not apt to suck infl ammable materials, toxics and fl uids.
The use of the vacuum cleaner is permitted to authorized operator only.
Do not wash the vacuum cleaner.
Use the vacuum cleaner exclusively for the function which it has been conceived for.
The constructor is not responsible for the damages caused by an improper use.
Vacuum cleaner Switch on / off .
To switch on/of the vacuum cleaner press on the switch 6.
Pos. 0 = Vacuum cleaner OFF, Pos. I = Vacuum cleaner ON.
!
Warning!
Before switch ON the vacuum cleaner, insert the electric
system of the machine by the switch 1 fi g.1 in position
1.
Replacing the refuse paper sack
- unlock the two closing hooks 4 (f g.11).
- remove cover 5 (f g.11).
- remove old sack and insert the new one.
- close the cover and lock it by its closing hooks.
Technical data:
- 24V motor, (f g.14 pos.3)
- vacuum 110 mBar
- air f ow 39 Lt/h
- capacity10 Lt (refuse paper sack - f g.14 pos.2)
- standard accessories Ø 35 (f g.11 pos.3)
OPTIONALS
BATTERY CHARGER ON BOARD (FIG.13)
VACUUM CLEANER ON BOARD (FIG.14)
Accessories
The standard kit includes:
- nozzle (A)
- brush (B)
- intake throat (C)
- f exible hose (D)
- extension (E)
Maintenance and cleaning
!
Warning!
Before executing the cleaning or maintenance op-
erations, make sure that the vacuum cleaner is not
in function, press on the switch 6 fi g.14 on position
"0" to switched OFF the electric system.
Remove the starter-key.
Use a cloth to clean the vacuum cleaner.
ENGLISH
43