Longitudinal Slicer; Change Of The Axis Slicer; Adjust Between Blades; Important - Merand AQUAPAN 100 Manual De Instrucciones

16.2. LONGITUDINAL SLICER

CHANGE OF THE AXIS SLICER

To change the product it's necessary to change de axis of the slicers of the longitudinal cut. The
procedure is the following:
- release the hook that subjects the guillotine and pull it up, like that you'll manage to reach at
the axis blade.
- Lift the lever (A figure 2) until the extremes of the axis of the slicers come out of the side
fixation.
- Now we have the screws free so that we can take them off, or change them for another axis for
a new product.
- The process for assembly is the same but the opposite way

ADJUST BETWEEN BLADES

Release the blades of the axis loosening the screws of the prisoner's screws A (figure 3).
Move the blades to their new position, and tighten again the prisoner's screws.

IMPORTANT:

Execute this operation with the blades of the axis out of the cutting station.
A
figure 2
A
figure 3
Page 32