Exit Band; Tighting Of The Transportation Band; Centring Of The Transportation Band - Merand AQUAPAN 100 Manual De Instrucciones

16.4. EXIT BAND

TIGHTING OF THE TRANSPORTATION BAND

The transportation band of the exit band of the guillotine can be tenses or loosened if the canvas
slipped over the screws or they were slowing.
For that, we will take off the side lid and we'll act on the tightening screws A (figure 5) situated
on both sides of the machine, in the interior part of the side band.
We'll loosen nut B with the screw, tightening or loosening the canvas always the same way on
both sides.
Always tighten the nut B when you've finished the tense operation
A
B
Important: it's not convenient to leave the band to tight.

CENTRING OF THE TRANSPORTATION BAND

If the band had any tendency to move sideways over the screws, you'll have to do the centring the
following way:
Tense slowly the transportation band only on the side where it moves to until you see that its starts to
move to the opposite side.
At this moment loosen slightly at that same side, until you observe that it keeps centred.
Repeat the process if it's necessary. The process of centring the band is slow and you need patience.
figure 5
Page 34