Use Of The Machine; Description Of The Controls - Merand AQUAPAN 100 Manual De Instrucciones

18.

USE OF THE MACHINE

18.1. DESCRIPTION OF THE CONTROLS

For the tension of the machine its necessary to press the principal switch A (figure 6) situated in the
dashboard of the controls on the side of the machine.
The button you press will lighten, and the machine will be ready to start working.
E B A
C D
Figure 6
the use of the machine will be made from the dashboard of the controls, situated in the bottom on the
table.
The controls are the following:
B Emergency switch: provokes the emergency stop of the machine. For starting the machine back
again its necessary to knock out of its position and press again the button to start.
C Switch for reset: it's to reset the machine after a stop.
D Switch of start/stop: to put on or off the machine. As well there is installed a button of on/off at the
end of the band at the exit, to help the recollection of the product.
E Guillotine switch: located al the side of the exit door of the machine. It is used for starting the
counter of the length of cut of the guillotine. When you press the guillotine switch, it does a cut and its
starts to count the length specified on the length cut parameter
F Programming console: Access to introduce and modify the parameters and the speed for the
different types of products that the machine can do and to start the different groups of the machine.
Page 36