baltur BT 40 DSN 4T Manual De Instrucciones página 20

HYDRAULIC SCHEMATIC DIAGRAM FOR TWO FLAME OR MODULATING BURNERS WITH HEAVY FUEL
OIL (MAX 50°E AT 50°C) WITH AN AUXILIARY HEATER
Note Fuel recovery tanks (diameter ~ 150 mm - height ~ 400
mm) must be installed as close as possible to the burner
at least 0.5 m above the burner pump.
1 MAIN TANK
2 FILTER
3 CIRCULATION PUMP
4 WATER AND SYSTEM OUTLET
5 AIR/GAS OUTLET - NORMALLY CLOSED
6 FUEL RECOVERY TANK AND DEGASSER
7 NON-RETURN VALVE
6 BY PASS (NORMALLY CLOSED)
9 PRESSURE REGULATOR THAT CAN BE SET 0.5- 2 BAR
10 PRESSURE GAUGE (0- 4 BAR)
11 THERMOMETER
12 RESISTANCE
13 AUXILIARY HEATER
14 STEAM OR HOT WATER OIL HEATING COIL
15 STEAM OR HOT WATER FUEL OIL HEATING COIL
16 TANK DIAMETER 100 MM HEIGHT 300 MM
HEATING ELECTRIC CABLE (IF NECESSARY)
18 / 40
0006081310_201211