Viking MT 5097 Manual De Instrucciones página 41

Press V-belt tensioner lever (1) forwards
and hold in place. Engage retainer (2) at
the frame as shown. Make sure that the V-
belt tensioner lever is fixed in the front
position.
Detaching the mowing deck at the rear:
Risk of injury!
The cutting height adjustment lever
is under tension when the mowing
deck is detached at the rear.
Therefore carefully set the highest
cutting level immediately after
detaching the mowing deck.
0478 192 9807 C - EN
Pull out cotter pin (1) upwards.
Lift up the mowing deck slightly and hold.
Push mounting (2) outwards and remove
retaining pin (3) from the mounting.
● Repeat this procedure on the other
side.
● Carefully and slowly set down the
mowing deck.
Detaching the V-belt:
Press retaining plate (1) forwards and hold
in place. Pull V-belt (2) forwards and
detach.
Releasing the V-belt from the tension
roller (MT 5112 Z, MT 6112 C,
MT 6112 ZL, MT 6127 ZL):
Push locking pin (1) approx. 0,5 cm
upwards and hold. Detach V-belt (2) from
tension roller (3).
After the V-belt is detached, push
the locking pin down again as far as
it will go until it engages in the
cover. After engagement, check
that the locking pin is securely
seated.
Detaching the mowing deck at the front
(MT 5097, MT 5097 C, MT 5097 Z):
39