Avertissements - Inglesina Kit Auto Maxi Manual De Instrucciones

H
I | J The carrycot cannot be positioned on one side and
fastened with the belt of the outermost seat from the other
side.
I
J
PREPARING THE VEHICLE SAFETY BELTS
fig. 12 Fasten both safety belts of the rear seat in the
vehicle (H), making sure there is sufficient space for the
carrycot to fit in.
A) Central option
B) Side option
LIRE LES
SUIVANTES ATTENTIVEMENT
AVANT
LES CONSERVER POUR LES BESOINS
ULTÉRIEURS DE RÉFÉRENCE. NE PAS
TENIR COMPTE DES MISES EN GARDE

AVERTISSEMENTS

INSTRUCTIONS
UTILISATION ET
fig. 13 Pull the back section of the safety belts upwards to
loosen them.
fig. 14 Engage the connection devices (C) making sure
that the red lever (I) is open.
fig. 15 Insert a section of the eyelet of the lumbar part
of the car's seat belt through the metal ring of one of the
connection devices (C).
fig. 16 Rotate the red lever (I) and insert it into the slot of
the vehicle's safety belt.
fig. 17 Lock the connection device (C) by pulling the
diagonal section of the seat belt of the car.
fig. 18 When necessary, move the connection device
(C) by lifting the eyelet of the car seat belt to make it slide.
Complete the operation repeating the instructions above for
the other seat belt.
FASTENING THE CARRYCOT
fig. 19 Place the carrycot on the rear seat of the vehicle.
The carrycot has 2 metal pegs (K) that are easily reached
externally on the head and feet areas.
fig. 20 To engage the connection devices (C) push them
against the carrycot pegs (K) until they click in position.
CAUTION! Ensure proper fastening by pulling the
connection devices upwards and downwards.
CAUTION! Always fasten both connection devices.
CAUTION! Ensure that the carrycot is firmly secured to
the seat by adjusting the car seat belt tensioner and,
when necessary, changing the position of the connection
devices.
fig. 21 To remove the carrycot from the seat, pull the red
lever (L) and push the connection device (C) upwards until
fully released.
POSITIONING THE BABY INTO THE CARRYCOT
fig. 22 Place the baby in the carrycot, buckle (M) up the
3-point harness.
fig. 23 Adjust the safety belt around the child by pulling
the adjustable sections to the left and right (N).
CAUTION! Adjust the 3-point harness in such a way that
the baby is secured but not tight.
fig. 24 Release it by pressing the red button on the first
adjuster (P) while pulling the fixed section of the lumbar belt.
fig. 25 Then repeat this on the second adjuster.
fig. 26 To release the harness, press the red button on the
buckle (M).
REMOVING/HOUSING THE RESTRAINT SYSTEM WHEN
NOT IN USE
fig. 27 Always remove the components of the Auto Kit's
strap assembly or place them in the properly seats on the
bottom, when the carrycot is not used for in-car transport,
for prolonged periods of sleep without the continuous
surveillance of an adult.
ET DES INSTRUCTIONS FOURNIES
PEUT S'AVÉRER TRÈS DANGEREUX
POUR VOTRE ENFANT.
VOUS ÊTES RESPONSABLE DE LA
SÉCURITÉ DE VOTRE ENFANT.
AVERTISSEMENT! NE JAMAIS LAISSER
21