Approvals; Fcc/Ic Information; Declaration Of Conformity - MicroPower Access 32 Instrucciones De Uso

Approvals

FCC/IC information

The product is FCC/IC registered and contains FCC ID: Z7H-EMB2538PA, IC: 21487-EMB2538PA.
Warning
Changes/modifications not approved by the responsible party could void the user's authority to operate
the equipment. This transmitter must not be relocated or operated in conjunction with any other antenna
or transmitter. This equipment complies with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated keeping the radiator at least
20 cm or more away from person's body (excluding extremities: hands, wrists, feet and ankles).
Avertissement
Les changements/modifications non approuvés par le parti responsable pourraient invalider l'autorité de
l'utilisateur à faire fonctionner l'équipement. Cet émetteur ne doit pas être relocalisé ou être utilisé avec
une autre antenne ou émetteur. Cet équipement est conforme aux limites d'exposition de émissions de
IC, FCC résentées pour un environnement non contrôlé. Cet équipement devrait être installé de façon à
ce que l'antenne soit éloigné de 20 centimètres ou plus du corps humain (en excluant les extrémités : les
mains, les poignets, les pieds et les chevilles).

Declaration of conformity

Manufacturer
Micropower E.D. Marke ng AB, Idavägen 1, 35246 Växjö, Sweden, tel +46 (0) 470-727400
Equipment
Ba ery charger MP Access 50, 100 and 200 with 24, 36, 48 or 80 VDC nominal output
and 208-240, 400 or 440 VAC nominal input.
The following direc ves and standards have been applied:
Note 1: If charger's rated output voltage is higher than 36 V it doesn't fulfil ar cle 10.101 ("The no load d.c output voltage shall not exceed
42,2V"). In some applica on is an addi onal resistor mounted between the secondary posi ve and protec ve earth for an improved ESD
protec on. In these case is not 13.3 and 16.3 fulfilled for the secondary side.
As manufacturer we declare under our sole responsibility that the equipment fulfils essen al
requirements for CE conformity according to applied direc ves and standards.
208
DECLARATION OF CONFORMITY
Low voltage direc ve 2014/35/EU
EN 60 335-1, EN 60 335-2-29
EMC direc ve 2014/30/EU
EN 61000-6-2, EN 610006-3
R&TTE direc ve 1999/5/EC
ETSI EN 301489-1, ETSI EN 301489-17
EU RoHS Direc ve 2011/65/EU
CE Marking Direc ve 93/68/EEC
Date
2016-08-24
1
Signature
Henrik Litsin
Position
R&D Manager