Surface Burners - Samsung NX58H9950W Serie Manual Del Usuario

Maintenance
CAUTION
• Do not leave racks in the oven during the self-cleaning cycle. The extreme heat
generated in this cycle can permanently peel off the rack coating and make it
difficult to remove the rack.
• Do not spray cooking oil or lubricant directly onto the gliding rack.
Door
Do not remove the inner gasket of the oven door for cleaning.
Inner side
• Inner surface: Clean the inner side of the door manually using a soapy plastic
scouring pad, and then wipe with a dry cloth. Take care not to get the gasket
wet or allow moisture into the door.
• Inner glass: The inner glass is cleaned automatically during the self-cleaning
cycle.
Outer side
• Outer surface: Follow the cleaning instructions for the stainless steel surface in
the previous section.
• Outer glass: Clean the outer glass using a glass cleanser or soapy water. Rinse
and dry thoroughly. Take care not to get the gasket wet or allow moisture into
the door.
*
CAUTION
Do not let moisture enter the door or
contact the door gasket (*). Moisture may
reduce the gasket's performance.

Surface burners

Burner controls
Make sure all surface burner knobs are in the OFF position.
CAUTION
• Do not clean the control knobs in a dish washer.
• Do not spray cleansers directly onto the control panel. Moisture entering the
electric circuits may cause electric shock or product damage.
Cooktop surface
The porcelain-enameled cooktop surface needs to be kept clean. It is advisable to
remove food spills immediately after they took place.
1. Pull out the knobs from the control
valve stems as shown.
2. Clean the knobs in warm, soapy water.
Then, rinse and dry them thoroughly.
3. Clean the stainless steel surfaces using
stainless steel cleaner.
4. Reinsert the knobs into the control
valve stems.
1. Turn off all surface burners.
2. Wait until all burner grates cool down,
and then remove them.
3. Clean the cooktop surface using a soft
cloth. If food spills run into gaps of the
burner components, remove the burner
cap and the head, and wipe out the
spills.
4. When cleaning is finished, reinsert the
burner components, and put the burner
grates into position.
English 45