Curve" Menu - Georges Renault DELTA4000 Manual Operario

{
Press to validate. The
¥
Press to display the print request screen:
Periph Selection of the peripheral: (parallel) printer or PC (serial link).
Header yes/no
Format Standard/Specific (see Appendix 1)
Date Reference date
Time Reference time
N. Meas Number of measurements: -X (nb of measurements saved) by default. The "minus" sign means
that the last X (nb of measurements saved) measurements obtained before the reference date
will be printed.
¦
Press to change the sign. Press
If the PC is selected as "peripheral", an application of data collection (hyperterminal type) should be used on it.

5.2 - "Curve" Menu

The curve of the last measurement is stored (the last 5 for the DELTA5000/5D); it can be displayed, printed or
transferred to the PC serial link (on which a data collection software, Hyperterminal type, should be used); then this
curve, the format of which is given in Appendix 3, can be displayed in a spreadsheet (Excel type).
See method to save this curve in Appendix.
For the DELTA5000/5D, the list of the last 5 curves saved is displayed (with the corresponding task name, no.5 being
the latest one). Select one of the curves by using ª or « .
©
Press to disable its validation individually, to keep it as a reference, for example. Press
validation.
{
Press to select:
Periph
Header
Type
¢
Press to display or transfer the curve.
The curve can be displayed on the screen of the DELTA. On the bottom line is shown the torque value identified by
means of the vertical cursor (positioned on the peak value by default); the cursor can be moved by using
¨
; the cursor can be moved faster using
The "zooming" function is activated in the following way:
¦
- Press
- 2 cursors are displayed (the cursor on the left-hand side blinks).
- This blinking cursor can be moved by using
{
- Press to select the right-hand cursor, and press the same key again to move the cursor.
¢
- Press to extend the display of the curve between the 2 cursors.
¤
- Press to display the initial scale.
On the other hand, on the screen displaying the curve, pressing on any of the digit keys no. 1 to 5 immediately displays
the corresponding curve.
In "hydro" mode, the curve only shows the torque "peaks" (whose values are above the measurement threshold). To
gain access to the time information between those "peaks", press
DELTA4000/5000/4D/5D
ª
key allows the operator to go back to the measurement number.
¥
again to start printing.
Selection of the peripheral: screen, (parallel) printer or (serial) PC
yes/no.
T=f(t) [torque versus time]
T+A=f(t) [torque and angle versus time] for the DELTA5000/5D
T=f(A) [torque versus angle] for the DELTA5000/5D
ª
and
« {
by pressing beforehand.
ª « © ¨
.
´
.
6159938010-07
English
13 / 200
¨
to enable again its
ª « ©